EGW mount benelli sbe2
EGW mount benelli sbe2
Will the holes on the egw mount line up with the factory drilled holes on the benelli sbe 2? Also will it sit snug on top of it? I like the sumtoy mount but I also like the way egw mounts have set holes for the screw not a slot like sumtoy
-
- Posts: 34
- Joined: July 31st, 2021, 6:36 pm
- Location: Pembroke, KY
- Contact:
Re: EGW mount benelli sbe2
If you are looking at the EGW optic base for the SBE,then yes the hole spacing will match the Benelli factory holes. https://www.egwguns.com/remington-4-6-7 ... rail-0-moa
Re: EGW mount benelli sbe2
I was referring to the red dot mount. Not the picatinny rail. Sorry for the confusionSteveRoseRAS wrote: ↑May 27th, 2023, 11:04 pm If you are looking at the EGW optic base for the SBE,then yes the hole spacing will match the Benelli factory holes. https://www.egwguns.com/remington-4-6-7 ... rail-0-moa
Re: EGW mount benelli sbe2
I used the EGW mount to put a Burris FF3 on my wife’s SBE2, no problems.
Re: EGW mount benelli sbe2
Did the mount line up on the back two holes or the front two holes towards the barrel? Reason I ask is online it says “front two holes only” for a sbe 2. Not sure if it meant front two holes on the mount or front two holes on the gun reciever
Re: EGW mount benelli sbe2
I have it mounted on the back two holes on the receiver.