20g choke for tss\steel

[jsh909]

Roll crimp

[Furyan]

Thank you

[jsh909]

Thank you

No problem. A fold crimp on that load sends you way over pressure

[Furyan]

That is a great load. Easy to build, loads up well and shoots very nicely. A lot of us guys on DHC shoot that load now. I should note that most just use a 2.75in hull and don't cut it down

Any idea on the over all finished cartridge length for this load , just got all the componants ill give it a try .

[Furyan]

Ok out this load https://www.duckhuntingchat.com/forum/v ... 4&t=893026 together and i can not get the OAL finished load near the stated length ? (Finished shells OAL = 2.450” to 2.453” )

Mine are bit longer at 2.59" ?

Only difference is My steel is copper palted which will not alter the OAL .

Those who use this load are you getting any powder migration past the wad ? this is my only fault using lilgun .