I'm looking to get a Savage 220a .410 (break action, single shot) threaded for choke tubes. Any recommendations on a good gunsmith that can do this with a fairly quick turnaround?
Sent from my SM-G970U using Tapatalk
Gunsmith Suggestions
Re: Gunsmith Suggestions
Contact Sumtoy !
The most experienced novice Turkey hunter the good Lord ever created !
-
- Posts: 6
- Joined: April 1st, 2020, 9:47 am
Re: Gunsmith Suggestions
Thanks for the info. I contacted them and he said he'd have to see my gun before he could say if he could do it or not.
Should have already done this, but it made me curious of the OD and ID of my barrel. This gun, at some point down the line and prior to me owning it, had a couple inches of the stock cut off and a few inches of barrel cut off. I figured that the muzzle end was pretty well open because of that.
Got the caliper out and to my surprise the ID is .380. I'm going to try it on paper as is with some TSS #9 and see what happens.
Sent from my SM-G970U using Tapatalk
Should have already done this, but it made me curious of the OD and ID of my barrel. This gun, at some point down the line and prior to me owning it, had a couple inches of the stock cut off and a few inches of barrel cut off. I figured that the muzzle end was pretty well open because of that.
Got the caliper out and to my surprise the ID is .380. I'm going to try it on paper as is with some TSS #9 and see what happens.
Sent from my SM-G970U using Tapatalk