Page 1 of 1
SX3 20ga Longbeard
Posted: February 4th, 2019, 11:05 pm
by Hoobilly
If you get the chance to buy a SX3 20ga Longbeard, jump on it. The Invector plus is absolutely crushing gobblers they pattern so well. Hers a duplex load of the 90/93 8x9’s at 40 yards with IndianCreek 562. This is a dirty barrel and starting to degrade the pattern.
Re: SX3 20ga Longbeard
Posted: February 5th, 2019, 8:30 am
by Fullfan
I have two of the X3 long beards, no doubt an optic is required due to the poor design of the sights. I shot mine with an IC .555 the factory and a Truelock .585, IC was to tight for my likings and the other two produced 300 ish in the 10@40. I think the guns are a tad bit heavy for a 20.
Re: SX3 20ga Longbeard
Posted: February 9th, 2019, 11:56 pm
by Hoobilly
Fullfan wrote: ↑February 5th, 2019, 8:30 am
I have two of the X3 long beards, no doubt an optic is required due to the poor design of the sights. I shot mine with an IC .555 the factory and a Truelock .585, IC was to tight for my likings and the other two produced 300 ish in the 10@40. I think the guns are a tad bit heavy for a 20.
if they weighted 6 to 6.5 lbs they would be ideal
Re: SX3 20ga Longbeard
Posted: February 10th, 2019, 10:52 am
by KyScott
Dead bird! Wish they made it with a 21” barrel. Heck I wish I could find a 21 incher for my SX2 12 gauge.
Re: SX3 20ga Longbeard
Posted: February 11th, 2019, 5:07 pm
by Hoobilly
KyScott wrote: ↑February 10th, 2019, 10:52 am
Dead bird! Wish they made it with a 21” barrel. Heck I wish I could find a 21 incher for my SX2 12 gauge.
Look for someone who has a stuck tube in a barrel etc and cut that thing down. Send to Briley and have it threaded
Re: SX3 20ga Longbeard
Posted: February 12th, 2019, 1:31 pm
by KyScott
hoobilly wrote: ↑February 11th, 2019, 5:07 pm
KyScott wrote: ↑February 10th, 2019, 10:52 am
Dead bird! Wish they made it with a 21” barrel. Heck I wish I could find a 21 incher for my SX2 12 gauge.
Look for someone who has a stick tube in a barrel etc and cut that thing down. Send to Briley and have it threaded
That my friend sounds like a great Idea!