SXP and 336 base
- tubecaller10
- Posts: 296
- Joined: August 6th, 2012, 5:08 pm
- Location: Mississippi
SXP and 336 base
Can u use manufacturers drill and tapped holes on SXP turkey edition and mount 336 base on two back holes?
Re: SXP and 336 base
Not unless you have the 336 drilled for 6/48 at the proper spacing.tubecaller10 wrote:Can u use manufacturers drill and tapped holes on SXP turkey edition and mount 336 base on two back holes?
- Hoobilly
- Gobbler Nation
- Posts: 13410
- Joined: August 15th, 2011, 10:15 pm
- Location: Argos Indiana
- Contact:
Re: SXP and 336 base
has anyone done this?Reloader wrote:Not unless you have the 336 drilled for 6/48 at the proper spacing.tubecaller10 wrote:Can u use manufacturers drill and tapped holes on SXP turkey edition and mount 336 base on two back holes?
reason I ask.. my son wants to have my SP10 drilled for scope / FF3
Re: SXP and 336 base
I've had quite a few drilled and tapped. You can have it done for any base you'd like. If going pic/weaver, find the base with the right radius and then have it d/t for it. The 336 is flat on the bottom, which is why it works on most guns due to the small flat or two high points ontop of the receiver. It's best to bed it as well.hoobilly wrote:has anyone done this?Reloader wrote:Not unless you have the 336 drilled for 6/48 at the proper spacing.tubecaller10 wrote:Can u use manufacturers drill and tapped holes on SXP turkey edition and mount 336 base on two back holes?
reason I ask.. my son wants to have my SP10 drilled for scope / FF3